RX 330 AWD V6-3.3L (3MZ-FE) (2004)
(2)
Remove the 2 hog rings from underneath the center seat.
(3)
Remove the 4 bolts and the center seat assembly.
D.
Remove the rear center seat armrest assembly. Using a "Torx" socket wrench (T45) remove the 2 "Torx" bolts and the center rear seat
armrest assembly.
Application Procedure
1.
Apply conditioner to the bottom of the seatback.
While holding the seatback cover apply conditioner in a 30 mm (1.2 in.) width area from the bottom end of the seatback cover.
NOTE
After conditioner is applied, avoid making contact with the surface until it is completely dry. (Summer season, approximately 1 minute, Winter
season, approximately 2 minutes).
2.
Apply conditioner to the left side of the RH rear seatback as shown in Figure 5.
NOTE
After conditioner is applied, avoid making contact with the surface until it is completely dry. (Summer season, approximately 1 minute, Winter
season, approximately 2 minutes).