RX 330 AWD V6-3.3L (3MZ-FE) (2004)
installation may seriously shorten the life of the radiator.
(a)
Reinstall the 4 bolt clips on to the radiator.
(b)
Install the No. 2 radiator assembly.
(c)
Slightly lift up on the No. 2 radiator assembly.
NOTE:
When installing the radiator support subassembly, raise the cooler condenser. At this point, be careful not to damage the cooler refrigerant
discharge pipe and the liquid tube sub-assembly.
(d)
Install the radiator support sub-assembly lower LH and RH with the 6 bolts.
TORQUE:
Bolt A: 5.0 Nm (51 kgf.cm, 44 in.lbf)
Bolt B: 3.9 Nm (40 kgf.cm, 35 in.lbf)
^
Install the radiator support sub-assembly upper LH and RH with the 6 bolts.
TORQUE:
Bolt A: 5.0 Nm (51 kgf.cm, 44 in.lbf)