RX 330 AWD V6-3.3L (3MZ-FE) (2004)
10. REMOVE EMISSION CONTROL VALVE SET
11. REMOVE INTAKE AIR SURGE TANK
12. REMOVE IGNITION COIL ASSY
13. REMOVE CYLINDER HEAD COVER SUB-ASSY
14. REMOVE ENGINE UNDER COVER ASSY (W/ ENGINE UNDER COVER ASSY)
15. REMOVE ENGINE UNDER COVER NO.1
16. REMOVE FRONT FENDER APRON SEAL RH
17. REMOVE V (COOLER COMPRESSOR TO CRANKSHAFT PULLEY) BELT NO.1
18. REMOVE VANE PUMP V BELT
19. REMOVE ENGINE MOVING CONTROL ROD
20. REMOVE ENGINE MOUNTING STAY NO.2 RH
21. REMOVE GENERATOR BRACKET NO.2
22. REMOVE CRANKSHAFT PULLEY
SST 09213-54015 (91651-60855), 09330-00021, 09950-50013 (09951-05010, 09952-05010, 09953-05020, 09954-05031)
23. REMOVE TIMING BELT NO.1 COVER
24. REMOVE TIMING BELT NO.2 COVER
25. REMOVE ENGINE MOUNTING BRACKET RH
26. REMOVE TIMING BELT GUIDE NO.2
27. REMOVE TIMING BELT
28. REMOVE TIMING BELT IDLER SUB-ASSY NO.2
29. REMOVE CAMSHAFT TIMING PULLEY
a. Using SST, remove the bolt and the RH timing pulley.
SST 09960-10010 (09962-01000, 09963-01000), 09249-63010
b. Using SST, remove the bolt and the LH timing pulley.
SST 09960-10010 (09962-01000, 09963-01000)
HINT: Arrange the camshaft timing pulleys (RH and LH sides) so that they can be returned to the original locations when re-assembling.
30. REMOVE TIMING BELT NO.3 COVER
a. Disconnect the 3 engine wire harness clamps from the timing belt No. 3 cover.
b. Remove the 6 bolts and the timing belt cover.
31. REMOVE CAMSHAFT