RX 330 AWD V6-3.3L (3MZ-FE) (2004)
5.
DISCONNECT THE HEATED 02 SENSORS
a.
For Bank 1 Sensor 2.
1.
Disconnect the heated Q2 sensor connector.
2.
Remove the connector clamp.
3.
Remove the two wire harness clamps.
NOTE:
Be careful not to damage the sensors while they are disconnected.
b.
For Bank 2 Sensor 2
1.
Disconnect the heated Q2 sensor connector.
2.
Remove the connector clamp.
3.
Remove the two wire harness clamps.
NOTE:
Be careful not to damage the sensors while they are disconnected.
6.
REMOVE THE FRONT SECTION OF THE DRIVE SHAFT TO THE REAR DIFFERENTIAL (4WD ONLY)