RX 330 AWD V6-3.3L (3MZ-FE) (2004)
/Page-1407010.png)
Torque: 25 N.m (250 kgf.cm, 18 in.lbf)
C.
Install the cooler compressor bracket with the 2 bolts and nut.
Bolt C Torque: 25 N.m (250 kgf.cm, 18 in.lbf)
Nut D Torque: 25 N.m (250 kgf.cm, 18 in.lbf)
Bolt E Torque: 18 N.m (184 kgf.cm, 13 in.lbf)
D.
Tighten the compressor and magnetic clutch with bolt F.
Torque: 25 N.m (250 kgf.cm, 18 in.lbf)
E.
Connect the connector and clamp on the cooler compressor bracket.
F.
Install the wire harness bracket with the bolt.
16.
Install cooler refrigerant suction hose No.1.
A.
Remove the attached vinyl tape from the hose.
B.
Sufficiently apply compressor oil to the NEW 0-ring and fitting surface of the compressor and magnetic clutch.
