RX 330 AWD V6-3.3L (3MZ-FE) (2004)
/Page-1456003.png)
CAUTION: If the LED comes on when the activation switch is not being pressed, SST(s) malfunction is possible, so be sure not to use the
SST(s).
3. Disconnect the SST(s) from the battery.
b. Disconnect the airbag connector.
1. Remove the roof headlining assy.
2. Using a screwdriver, disconnect the curtain shield airbag LH connector.
c. Install the SST(s).
1. Connect the connector of the SST(s) to the curtain shield airbag assy LH.
SST 09082-00700, 09082-00802 (09082-10801, 09082-20801)
NOTE: To avoid damaging the SST(s) connector and wire harness, do not lock the secondary lock of the twin lock.
2. Move the SST(s) to at least 10 m (33 ft) away from the rear of the vehicle.
3. Close vehicle doors and windows.
NOTE: Take care not to damage the SST(s) wire harness.
4. Connect the red clip of the SST(s) to the battery positive (+) terminal and the black of the SST(s) clip to the negative (-) terminal.
d. Deploy the airbag.
1. Check that no one is inside the vehicle or within a 10 m (33 ft) radius of the vehicle.
2. Press the activation switch of the SST(s) and deploy the airbag.
HINT: The airbag is deployed as the LED of the SST(s) activation switch comes on.
e. Dispose of the curtain shield airbag assy LH.
CAUTION:
-
The curtain shield airbag assy LH is extremely hot when the airbag is deployed, so do not touch it for at least 30 minutes after deployment.
-
Use gloves and safety glasses when handling the curtain shield airbag assy LH with the deployed airbag.
-
When moving the vehicle for scrapping which has the curtain shield airbag assy LH with the deployed air-bag, use gloves and safety glasses.
-
Do not apply water, etc.to the curtain shield airbag assy LH with the deployed airbag.
-
Always wash your hands with water after completing the operation.
HINT: When scrapping a vehicle, deploy the airbag and scrap the vehicle with the curtain shield airbag assy LH still installed.
LH (When Disposing of Airbag Assembly Deployment Method)
DISPOSAL
