lexus Workshop Repair Guides

Lexus Workshop Service and Repair Manuals

Procedures|Page 7957 > < Procedures|Page 7955
Page 41
background image

HINT:  Do not connect the yellow connector of the SST(s) which is to be connected with the supplemental restraint system.

2. Check the function of the SST(s).

Press the SST(s) activation switch, and check that the LED of the SST(s) activation switch comes on.

CAUTION:  If the LED comes on when the activation switch is not being pressed, SST(s) malfunction is possible, so be sure not to use the
SST(s).

3. Disconnect the SST(s) from the battery.

b. Remove the instrument panel airbag assy lower No.1.

CAUTION:
-

When removing the instrument panel airbag assy lower No.1, work must be started 90 seconds after the ignition switch is turned to the
"LOCK" position and the negative (-) terminal cable is disconnected from the battery.

-

When storing the instrument panel airbag assy lower No.1, keep the upper surface of the airbag deployment side facing upward.

c. Using a service-purpose wire harness for the vehicle, tie down the instrument panel airbag assy lower No.1 to the tire.

Wire harness: Stripped wire harness section 1.25 sq.mm or more (0.0019 sq.in or more)

CAUTION:  If the wire harness which is too thin or an alternative object is used to tie down the instrument panel airbag assy lower No.1, it may
be snapped by the shock when the airbag is deployed.Always use a wire harness for vehicle use which has a diameter of at least 1.25 sq.mm
(0.0019 sq.in.).

HINT:
-

To calculate the square of the stripped wire harness section:
Square = 3.14 x sq.(Diameter) divided by 4

-

Position the instrument panel airbag assy lower No.1 inside the tire with the airbag deployment side facing inside.
Tire size: Must exceed the following dimensions
Width: 185 mm (7.28 in.)
Inner diameter: 360 mm (14.17 in.)

CAUTION:
-

Make sure that the wire harness is tight.It is highly dangerous when looseness in the wire harness results in the instrument panel airbag assy
lower No.1 coming free due to the shock from the airbag deployment.

-

Always tie down the instrument panel airbag assy lower No.1 with the airbag deployment side facing inside the tire.

Procedures|Page 7957 > < Procedures|Page 7955