RX 330 AWD V6-3.3L (3MZ-FE) (2004)
Apply MP grease No.2 to prevent the oil seal lip from rolling back.
D. Insert the SST into the transfer RH bearing retainer sub-assembly.
SST P/N 09387-00090
NOTICE
Insert the SST straight in order NOT to damage the oil seal.
E. With the SST and the transfer RH bearing sub-assembly in close contact install the transfer RH bearing retainer sub-assembly together with the
SST into the transfer case.
NOTICE
^
Avoid interference between the case and the retainer and between the SST and the transfer ring gear mounting case.
^
Carefully check the retainer's 0-ring for damage and incorrect fitting.
HINT
^
If the engagement is tight, tap the SST with a hammer placing a brass bar on the center of the SST.