RX 330 AWD V6-3.3L (3MZ-FE) (2004)
D.
Using the SST, remove the RH bearing retainer from the transfer case.
^
SST P/N 09520-10021
10.
Remove the transfer RH bearing retainer 0-ring.
Using a screwdriver with the tip protected with tape, remove the two (2) 0-rings from the RH bearing retainer.
Be careful NOT to damage the retainer's groove for the 0-ring.
11.
Remove the center differential case tapered roller bearing.
A.
Hold the RH bearing retainer in a vise.
B.
Using the SST, remove the outer race, washer, and No. 2 oil seal from the RH bearing retainer.
^
SST P/N 09308-00010
NOTE:
Be careful NOT to damage the oil-seal-fitted surface of the retainer.
Repair Procedure: Installation
1.
Install a NEW No. 2 oil seal in the RH bearing retainer.