RX 330 AWD V6-3.3L (3MZ-FE) (2004)
2. Lightly press the front surface of the glass to ensure a close fit.
3. Using a scraper, remove any excess or protruding adhesive.
HINT: Apply adhesive onto the glass rim.
NOTE: Take care not to drive the vehicle for the time described in the table.
16. w/ Rain sensor:
INSTALL RAIN SENSOR
a. If reusing the rain sensor: Install new rain sensor tape.
1. Remove the used rain sensor tape from the windshield glass or rain sensor.
2. Apply new rain sensor tape on the lens surface of the rain sensor indicated by the hatched area.
NOTE:
-
Make sure that no dust or fingerprints are on the sheet surface.
-
Apply the sheet so that it will not come off from the area it is applied to.
b. Install the rain sensor.
NOTE: