RX 350 FWD V6-3.5L (2GR-FE) (2010)
After the engine switch is turned off, the display and navigation module display (HDD navigation system) records various types of
memory and settings. As a result, after turning the engine switch off, make sure to wait at least 60 seconds before disconnecting the
cable from the negative (-) battery terminal.
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system See: Restraint
Systems/Air Bag Systems/Service Precautions.
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning/Repair Instruction - Initialization.
3. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Removal and Replacement/Removal
4. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument
Panel/Service and Repair/Removal and Replacement/Removal
5. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument
Panel/Service and Repair/Removal and Replacement/Removal
6. REMOVE FRONT DOOR SCUFF PLATE RH See: Lighting and Horns/Courtesy Lamp/Glove Box Lamp/Service and Repair/Removal
7. REMOVE COWL SIDE TRIM SUB-ASSEMBLY RH See: Lighting and Horns/Courtesy Lamp/Glove Box Lamp/Service and Repair/Removal
8. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Dashboard /
Instrument Panel/Service and Repair/Removal and Replacement/Removal
9. REMOVE INSTRUMENT PANEL GARNISH RH See: Lighting and Horns/Courtesy Lamp/Glove Box Lamp/Service and Repair/Removal
10. REMOVE FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY See: Restraint Systems/Air Bag Systems/Air Bag/Service and
Repair/Removal and Replacement/Knee Airbag Assembly (for Front Passenger Side)/Removal
11. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument
Panel/Service and Repair/Removal and Replacement/Removal
12. DISCONNECT CONNECTOR HOLDER
(a) Disengage the clamp and disconnect the wire harness.
(b) Remove the nut.
(c) Disengage the claw and disconnect the connector holder.
13. REMOVE ECU INTEGRATION BOX
(a) Remove the bolt, 2 nuts and ECU integration box.
14. REMOVE CLEARANCE WARNING ECU ASSEMBLY
(a) Disengage the 2 claws and remove the clearance warning ECU assembly.