RX 350 FWD V6-3.5L (2GR-FE) (2010)
HINT
Use the same procedure for the RH side and the LH side.
From 08/2009
PARK ASSIST / MONITORING: ULTRASONIC SENSOR (for Rear Side): REMOVAL
1. REMOVE NO. 2 LUGGAGE COMPARTMENT SIDE COVER PROTECTOR See: Body and Frame/Bumper/Rear Bumper/Service and
Repair/Removal and Replacement/Removal
2. REMOVE NO. 1 LUGGAGE COMPARTMENT SIDE COVER PROTECTOR See: Steering and Suspension/Suspension/Suspension Control (
Automatic - Electronic )/Compressor/Pump/Service and Repair/Removal
3. REMOVE REAR BUMPER ASSEMBLY See: Body and Frame/Bumper/Rear Bumper/Service and Repair/Removal and Replacement/Removal
4. REMOVE NO. 1 ULTRASONIC SENSOR (for Back Sensor)
(a) Disconnect the connector.
HINT
The illustration is for the LH side. The RH side is the opposite of the LH side.
(b) Disengage the 2 claws as shown in the illustration and release the lock and remove the No. 1 ultrasonic sensor.
HINT
The illustration is for the LH side. The RH side is the opposite of the LH side.
5. REMOVE NO. 1 ULTRASONIC SENSOR RETAINER (for Back Sensor)
(a) Disengage the 2 claws and remove the No. 1 ultrasonic sensor retainer.
HINT
The illustration is for the LH side. The RH side is the opposite of the LH side.
6. REMOVE NO. 1 ULTRASONIC SENSOR (for Corner Sensor)
(a) Disconnect the connector.
HINT
Use the same procedure for the RH side and the LH side.