RX 350 FWD V6-3.5L (2GR-FE) (2010)
G. Disengage the 4 claws and 4 guides and remove the rear bumper assembly as shown in the illustration.
5. Remove both the left and right side rear bumper supports and discard.
A. Remove the 2 screws.
B. Disengage the 2 claws and remove the rear bumper side supports and discard.
6. Send the vehicle to the body shop for painting and finishing of the new bumper cover. Refer to the Technical Information System (TIS) and the
following manuals:
^
Lexus Fundamental Body Repair Procedures manual
^
Complete set of Lexus Collision Repair manuals
7. Transfer components from original bumper cover to new bumper cover please refer to TIS for procedure.
^
2010 RX 350 vehicles with a production date of 07/2009 and earlier
Vehicle Exterior - Exterior Panels/Trim - "Rear Bumper: Disassembly / Reassembly"