RX 350 FWD V6-3.5L (2GR-FE) (2010)
^
2010 RX 350 vehicles with a production date of 08/2009 and later
Vehicle Exterior - Exterior Panels/Trim - "Rear Bumper: Disassembly / Reassembly
8. Install the New left and right side rear bumper supports.
A. Engage the 2 claws.
B. Install the rear bumper side support LH with the 2 screws.
Torque: 7.5 N*m (77 kgf*cm, 66 in*lbf)
HINT
Use the same procedure for the RH side and LH side.
9. Install rear bumper assembly.
A. Connect the No.3 luggage room wire harness connector.