RX 350 FWD V6-3.5L (2GR-FE) (2010)
24. INSTALL FRONT DOOR OUTSIDE HANDLE COVER WITH LOCK CYLINDER ASSEMBLY (for Driver Side)
(a) Install the front door outside handle cover with lock cylinder assembly.
HINT
Make sure that the front door lock cylinder rod is inserted into the front door lock assembly.
(b) Using a T30 "TORX" socket wrench, install the front door lock cylinder with the screw.
Torque : 4.0 Nm (41 kgf-cm, 35 in-lbf)
(c) Install the hole plug.
25. INSTALL FRONT DOOR REAR LOWER FRAME SUB-ASSEMBLY
(a) Install the front door rear lower frame sub-assembly with the bolt as shown in the illustration.
26. INSTALL FRONT DOOR GLASS RUN
(a) Install the front door glass run.
27. INSTALL FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY
NOTICE:
The regulator arm must be below the intermediate position when installing the power window regulator motor.
(a) Using a T25 "TORX" socket wrench, install the front power window regulator motor assembly with the 3 screws.