RX 350 FWD V6-3.5L (2GR-FE) (2010)
20. REMOVE FRONT DOOR SERVICE HOLE COVER
(a) Disconnect the connector.
(b) Remove the front door service hole cover.
HINT
Remove any remaining butyl tape from the door.
21. REMOVE OUTER MIRROR PROTECTOR See: Mirrors/Service and Repair/Removal and Replacement/Outer Rear View Mirror/Removal
22. REMOVE OUTER MIRROR INSTALL HOLE COVER See: Mirrors/Service and Repair/Removal and Replacement/Outer Rear View
Mirror/Removal
23. REMOVE OUTER REAR VIEW MIRROR ASSEMBLY See: Mirrors/Service and Repair/Removal and Replacement/Outer Rear View
Mirror/Removal
24. REMOVE FRONT DOOR GLASS SUB-ASSEMBLY
(a) Connect the cable to the negative (-) battery terminal.
(b) Connect the power window regulator master switch assembly and move the front door glass sub-assembly so that the door glass bolts can be
seen.
(1) w/ Navigation System for HDD:
NOTICE:
After the engine switch is turned off, the display and navigation module display (HDD navigation system) records various types of
memory and settings. As a result, after turning the engine switch off, make sure to wait at least 60 seconds before disconnecting the
cable from the negative (-) battery terminal.
(c) Disconnect the cable from the negative (-) battery terminal and power window regulator master switch assembly.
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system See: Restraint
Systems/Air Bag Systems/Service Precautions.
(d) Remove the 2 bolts.
NOTICE:
After the bolts are removed, do not allow the door glass to fall.
(e) Remove the front door glass sub-assembly as indicated by the arrows in the order shown in the illustration.