RX 350 FWD V6-3.5L (2GR-FE) (2010)
Text in Illustration
35. REMOVE REAR DOOR OUTSIDE MOULDING SUB-ASSEMBLY See: Exterior Moulding / Trim/Lower Side Moulding / Trim/Service and
Repair/Removal
36. REMOVE REAR DOOR BELT MOULDING ASSEMBLY
37. REMOVE REAR DOOR FRONT WINDOW FRAME MOULDING SUB-ASSEMBLY
38. REMOVE REAR DOOR REAR WINDOW FRAME MOULDING
39. REMOVE REAR DOOR UPPER WINDOW FRAME MOULDING
Up to 08/2009
DOOR / HATCH: REAR DOOR: REASSEMBLY
1. INSTALL REAR DOOR UPPER WINDOW FRAME MOULDING
2. INSTALL REAR DOOR REAR WINDOW FRAME MOULDING
3. INSTALL REAR DOOR FRONT WINDOW FRAME MOULDING SUB-ASSEMBLY
4. INSTALL REAR DOOR BELT MOULDING ASSEMBLY
5. INSTALL REAR DOOR OUTSIDE MOULDING SUB-ASSEMBLY See: Exterior Moulding / Trim/Lower Side Moulding / Trim/Service and
Repair/Installation
6. INSTALL NO. 2 ACCESS PANEL WEATHERSTRIP
HINT
When installing the No. 2 access panel weatherstrip, heat the rear door panel protector and No. 2 access panel weatherstrip using a
heat light.
Heating Temperature
NOTICE:
Do not heat the rear door panel protector or No. 2 access panel weatherstrip excessively.
(a) Using a heat light, heat the rear door panel protector surface.
(b) Remove the double-sided tape from the rear door panel protector.
(c) Wipe off any tape adhesive residue with cleaner.
(d) If reusing the No. 2 access panel weatherstrip:
(1) Using a heat light, heat the No. 2 access panel weatherstrip.