RX 350 FWD V6-3.5L (2GR-FE) (2010)
(a) Using a heat light, heat the vehicle body surface.
(b) Remove the double-sided tape from the vehicle body.
(c) Wipe off any tape adhesive residue with cleaner.
(d) If reusing the rear door panel protector:
(1) Using a heat light, heat the rear door panel protector.
(2) Clean the rear door panel protector.
(3) Remove the double-sided tape from the rear door panel protector.
(4) Wipe off any tape adhesive residue with cleaner.
(5) Apply new double-sided tape to the rear door panel protector as shown in the illustration.
(e) Engage the 11 clips and guide to install the rear door panel protector as shown in the illustration.
Text in Illustration
8. INSTALL REAR DOOR LOWER OUTSIDE MOULDING See: Exterior Moulding / Trim/Lower Side Moulding / Trim/Service and
Repair/Installation
9. INSTALL REAR DOOR OUTSIDE HANDLE FRAME SUB-ASSEMBLY
(a) Apply MP grease to the sliding parts of the rear door outside handle frame sub-assembly.
(b) Engage the door handle nut and claw.