RX 350 FWD V6-3.5L (2GR-FE) (2010)
WINDOW / GLASS: POWER WINDOW REGULATOR MOTOR (for Rear Door): REMOVAL
NOTICE:
*
Use the same procedure for the RH side and LH side.
*
The procedure listed below is for the LH side.
1. PRECAUTION
NOTICE:
After the engine switch is turned off, the display and navigation module display (HDD navigation system) records various types of
memory and settings. As a result, after turning the engine switch off, make sure to wait at least 60 seconds before disconnecting the
cable from the negative (-) battery terminal.
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning/Repair Instruction - Initialization.
3. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG See: Service and Repair/Overhaul/Disassembly
4. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL See: Service
and Repair/Overhaul/Disassembly
5. REMOVE REAR DOOR ARMREST COVER See: Service and Repair/Overhaul/Disassembly
6. REMOVE COURTESY LIGHT ASSEMBLY See: Lighting and Horns/Courtesy Lamp/Service and Repair/Vehicle Interior/Door Courtesy
Light/Removal
7. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY See: Service and Repair/Overhaul/Disassembly
8. REMOVE REAR DOOR INNER GLASS WEATHERSTRIP See: Service and Repair/Overhaul/Disassembly
9. REMOVE REAR DOOR FRAME GARNISH See: Service and Repair/Overhaul/Disassembly
10. REMOVE REAR DOOR TRIM BRACKET See: Service and Repair/Overhaul/Disassembly
11. REMOVE REAR DOOR SERVICE HOLE COVER See: Service and Repair/Overhaul/Disassembly
12. REMOVE REAR DOOR GLASS RUN See: Service and Repair/Overhaul/Disassembly
13. REMOVE REAR DOOR WINDOW REAR GUIDE SUB-ASSEMBLY See: Service and Repair/Overhaul/Disassembly
14. REMOVE REAR DOOR REAR GUIDE SEAL See: Service and Repair/Overhaul/Disassembly
15. REMOVE REAR DOOR GLASS SUB-ASSEMBLY See: Service and Repair/Overhaul/Disassembly
16. REMOVE REAR DOOR WINDOW REGULATOR ASSEMBLY See: Service and Repair/Overhaul/Disassembly
17. REMOVE REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY
(a) Using a T25 "TORX" socket wrench, remove the 3 screws and the rear power window regulator motor assembly.