RX 350 FWD V6-3.5L (2GR-FE) (2010)
Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)
11. INSTALL REAR SUSPENSION MEMBER UPPER STOPPER
(a) Install the 2 rear suspension member upper stoppers as shown in the illustration.
NOTICE:
Be sure to install the rear suspension member upper stoppers in the correct direction shown in the illustration.
12. INSTALL REAR SUSPENSION MEMBER REAR UPPER STOPPER
(a) Install the 2 rear suspension member rear upper stoppers as shown in the illustration.
13. INSTALL REAR SUSPENSION MEMBER SUB-ASSEMBLY
(a) Support the rear suspension member with a jack using 2 wooden blocks and 2 attachments or equivalent tools as shown in the illustration.
Text in Illustration
NOTICE:
Make sure to secure the rear suspension member to prevent it from dropping.
HINT
Keep the suspension member level.
(b) Raise the rear suspension member until there is no clearance between the rear suspension member and the body.
NOTICE:
*
When raising the rear suspension member, be careful not to damage the vehicle body or other components installed on the vehicle.
*
Keep supporting the rear suspension member until the installation has been completed.
(c) Temporarily tighten the rear No. 1 suspension arm assembly LH.
(1) Using a jack and wooden block, jack up the rear axle assembly LH to replicate standard vehicle height conditions.