RX 350 FWD V6-3.5L (2GR-FE) (2010)
HINT
A part of the clip remains on the vehicle side.
(b) w/ Illumination:
(1) Disconnect the connector.
4. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH
(a) Remove the clip.
(b) Disengage the 2 clips and remove the cowl side trim sub-assembly LH.
5. REMOVE INSTRUMENT SIDE PANEL LH
(a) Using moulding remover A, disengage the claw and 2 clips.
(b) Disengage the guide and remove the instrument side panel LH.
6. REMOVE FRONT PILLAR GARNISH LH
(a) Pull the upper part of the garnish toward the inside of the cabin and disengage the 2 clips.
HINT
Perform this step as shown by the arrow (1) in the illustration.
(b) Cut off the clip [A].
(c) Disengage the 2 guides and remove the front pillar garnish LH.
HINT
Perform this step as shown by the arrow (2) in the illustration.