RX 350 FWD V6-3.5L (2GR-FE) (2010)
(2) Peel off the appropriate amount of new double sided tape.
NOTICE:
Be careful not to touch the adhesive surface.
(3) Apply the double-sided tape to the roof headlining while aligning the tape with the markings on the roof headlining assembly.
(4) Peel off the backing sheet from the double sided tape.
(b) Install the rear No. 3 washer hose to the roof headlining assembly from the front of the vehicle.
Text in Illustration
HINT
*
For the right front corner [A] of the roof headlining assembly, align the marking tape (green) on the rear No. 3 washer hose with
the protrusion of the roof headlining (for TMC Made).
*
For the right front corner [A] of the roof headlining assembly, align the marking tape (blue) on the rear No. 3 washer hose with
the protrusion of the roof headlining (for TMMC Made).
*
For the right rear corner [B] of the roof headlining assembly, align the marking tape (green) on the rear No. 3 washer hose with
the marking of the roof headlining (for TMC Made).
*
For the right rear corner [B] of the roof headlining assembly, align the marking tape (blue) on the rear No. 3 washer hose with the
marking of the roof headlining (for TMMC Made).
*
If the entire length of the rear No. 3 washer hose does not fit, adjust the length by tucking in the hose at the area shown in the
illustration.
32. INSTALL NO. 2 ANTENNA CORD SUB-ASSEMBLY See: Accessories and Optional Equipment/Antenna/Antenna, Radio/Antenna
Cable/Service and Repair/Installation
33. INSTALL VANITY LIGHT ASSEMBLY
(a) Install the vanity light assembly See: Lighting and Horns/Vanity Lamp/Service and Repair/Installation.
HINT
Use the same procedure to remove the light on the other side.