RX 350 FWD V6-3.5L (2GR-FE) (2010)
NOTICE:
After the engine switch is turned off, the display and navigation module display (HDD navigation system) records various types of
memory and settings. As a result, after turning the engine switch off, make sure to wait at least 60 seconds before disconnecting the
cable from the negative (-) battery terminal.
2. PRECAUTION
CAUTION:
Be sure to read Precaution thoroughly before servicing See: Restraint Systems/Air Bag Systems/Service Precautions.
3. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD
4. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL See: Steering and Suspension/Steering/Steering Column/Service and
Repair/Removal and Replacement/Removal
5. REMOVE LOWER NO. 3 STEERING WHEEL COVER See: Restraint Systems/Air Bag Systems/Air Bag/Service and Repair/Removal and
Replacement/Steering Pad/Removal
6. REMOVE LOWER NO. 2 STEERING WHEEL COVER See: Restraint Systems/Air Bag Systems/Air Bag/Service and Repair/Removal and
Replacement/Steering Pad/Removal
7. REMOVE STEERING PAD See: Restraint Systems/Air Bag Systems/Air Bag/Service and Repair/Removal and Replacement/Steering
Pad/Removal
8. REMOVE STEERING WHEEL ASSEMBLY See: Steering and Suspension/Steering/Steering Wheel/Service and Repair/Removal
9. REMOVE LOWER STEERING COLUMN COVER See: Steering and Suspension/Steering/Steering Column/Service and Repair/Removal and
Replacement/Removal
10. REMOVE UPPER STEERING COLUMN COVER See: Steering and Suspension/Steering/Steering Column/Service and Repair/Removal and
Replacement/Removal
11. REMOVE SPIRAL CABLE WITH STEERING ANGLE SENSOR
(a) Remove the spiral cable with steering angle sensor See: Restraint Systems/Air Bag Systems/Clockspring Assembly / Spiral Cable/Service
and Repair/Removal.
NOTICE:
*
Do not replace the spiral cable with the battery connected and the engine switch on (IG).
*
Do not rotate the spiral cable with the battery connected and the engine switch on (IG).
*
Ensure that the steering wheel is installed and aligned straight when inspecting the steering angle sensor.
*
Do not remove the steering angle sensor from the spiral cable.