RX 350 FWD V6-3.5L (2GR-FE) (2010)
Be sure to insert the No. 1 sensor clamp into the stopper hole while installing the No. 1 sensor clamp.
(c) Install the front brake flexible hose and No. 1 sensor clamp together to the shock absorber with the bolt.
Text in Illustration
Torque : 19 Nm (194 kgf-cm, 14 ft-lbf)
NOTICE:
*
Do not twist the wire harness for the front speed sensor when installing it.
*
A bolt tightens the brake flexible hose and front speed sensor together. Make sure that the flexible hose is positioned over the front
speed sensor.
(d) Install the No. 2 sensor clamp to the body with the bolt.
Text in Illustration
Torque : 8.0 Nm (82 kgf-cm, 71 in-lbf)
(e) Install the 2 clamps and connect the front speed sensor connector.
(f) Install the front fender liner with the 5 clips and 3 screws.
(g) Install the 2 pin hold clips.