RX 350 FWD V6-3.5L (2GR-FE) (2010)
(b) Install the No. 1 bracket with the bolt.
Torque : 8.0 Nm (82 kgf-cm, 71 in-lbf)
7. INSTALL REAR SUSPENSION ARM COVER See: Steering and Suspension/Suspension/Control Arm/Service and Repair/Rear Lower
Arm/Installation
8. INSTALL REAR WHEEL
Torque : 103 Nm (1050 kgf-cm, 76 ft-lbf)
9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning/Repair Instruction - Initialization.
10. INSPECT AND ADJUST REAR WHEEL ALIGNMENT
HINT
See: Maintenance/Alignment/Service and Repair/Rear Wheel Alignment.
11. CHECK FOR SPEED SENSOR SIGNAL
HINT
See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Test Mode Procedure.
From 08/2009
BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: REAR SPEED SENSOR (for 2WD): INSTALLATION
HINT
*
Use the same procedure for the RH side and LH side.
*
The following procedure is for the LH side.
*
The rear speed sensor is a component of the rear axle hub and bearing assembly. If the sensor malfunctions, replace the rear axle
hub and bearing assembly.
*
If the sensor rotor needs to be replaced, replace it together with the rear axle hub and bearing assembly.
1. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY
(a) Install the rear axle hub and bearing assembly See: Maintenance/Wheels and Tires/Wheel Hub/Service and Repair/Rear Axle
Hub/Installation.
HINT
*
The rear speed sensor is a component of the rear axle hub and bearing assembly. If the sensor malfunctions, replace the rear axle
hub and bearing assembly.
*
If the sensor rotor needs to be replaced, replace it together with the rear axle hub and bearing assembly.
2. INSPECT REAR AXLE HUB BEARING LOOSENESS See: Maintenance/Wheels and Tires/Wheel Hub/Testing and Inspection/Rear Axle Hub
3. INSPECT REAR AXLE HUB RUNOUT See: Maintenance/Wheels and Tires/Wheel Hub/Testing and Inspection/Rear Axle Hub
4. INSTALL REAR DISC See: Disc Brake System/Service and Repair/Removal and Replacement/Rear Brake/Installation
5. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY See: Parking Brake System/Service and Repair/Overhaul/Reassembly