RX 350 FWD V6-3.5L (2GR-FE) (2010)
6. INSTALL REAR SPEED SENSOR WIRE
(a) Connect the connector to the rear speed sensor.
(b) Install the No. 1 bracket with the bolt.
Torque : 8.0 Nm (82 kgf-cm, 71 in-lbf)
7. INSTALL REAR SUSPENSION ARM COVER See: Steering and Suspension/Suspension/Control Arm/Service and Repair/Rear Lower
Arm/Installation
8. INSTALL REAR WHEEL
Torque : 103 Nm (1050 kgf-cm, 76 ft-lbf)
9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning/Repair Instruction - Initialization.
10. INSPECT AND ADJUST REAR WHEEL ALIGNMENT
HINT
See: Maintenance/Alignment/Service and Repair/Rear Wheel Alignment.
11. CHECK FOR SPEED SENSOR SIGNAL
HINT
See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Test Mode Procedure.