RX 350 FWD V6-3.5L (2GR-FE) (2010)
(c) Remove the 4 nuts and brake pedal support assembly from the body.
Up to 08/2009
BRAKE SYSTEM (OTHER): BRAKE PEDAL: INSTALLATION
1. INSTALL BRAKE PEDAL SUPPORT ASSEMBLY
(a) Install the brake pedal support assembly with the 4 nuts.
Torque : 13 Nm (130 kgf-cm, 9 ft-lbf)
(b) Install the brake pedal support assembly to the instrument panel reinforcement with the 2 bolts.
Torque : 35 Nm (357 kgf-cm, 26 ft-lbf)
(c) Connect the brake pedal load sensing switch connector and engage the clamp.
2. CONNECT BRAKE MASTER CYLINDER PUSH ROD CLEVIS
(a) Apply lithium soap base glycol grease to the push rod pin.
(b) Connect the brake master cylinder push rod clevis to the brake pedal with the push rod pin, and install a new clip as shown in the illustration.