RX 350 FWD V6-3.5L (2GR-FE) (2010)
Torque : 19 Nm (194 kgf-cm, 14 ft-lbf)
2. FILL RESERVOIR WITH BRAKE FLUID See: Brake Fluid/Service and Repair
3. BLEED BRAKE LINE See: Brake Fluid/Service and Repair
4. INSPECT FOR BRAKE FLUID LEAK
5. INSPECT FLUID LEVEL See: Brake Fluid/Testing and Inspection
6. INSTALL FRONT WHEEL
Torque : 103 Nm (1050 kgf-cm, 76 ft-lbf)
From 08/2009
BRAKE (FRONT): FRONT BRAKE FLEXIBLE HOSE: INSTALLATION
NOTICE:
*
Because the left and right hoses are not interchangeable, verify the part number when installing the flexible hoses.
*
If the hoses are to be reused, connect them after checking the identification marks placed when each hose was disconnected.
HINT
*
Use the same procedure for the LH side and RH side.
*
The following procedure is for the LH side.
1. INSTALL FRONT FLEXIBLE HOSE
(a) Connect the front flexible hose to the disc brake cylinder assembly with the union bolt and a new gasket.
Torque : 30 Nm (306 kgf-cm, 22 ft-lbf)
(b) Install the front flexible hose with a new clip.
NOTICE:
Install the clip as far as it will go.
(c) Using a union nut wrench, connect the brake line to the front flexible hose.
Torque : 15 Nm (155 kgf-cm, 11 ft-lbf)
NOTICE: