RX 350 FWD V6-3.5L (2GR-FE) (2010)
Torque : 8.0 Nm (82 kgf-cm, 71 in-lbf)
(e) Install the 2 clamps and connect the front speed sensor connector.
(f) Install the front fender liner with the 5 clips and 3 screws.
(g) Install the 2 pin hold clips.
Text in Illustration
NOTICE:
Insert the pin hold clips with the slots aligned vertically. Do not rotate the clips after inserting them. After installation, confirm that
the slots are vertical.
HINT
Use the same procedure for the RH side and LH side.
2. INSTALL FRONT WHEEL
Torque : 103 Nm (1050 kgf-cm, 76 ft-lbf)