RX 350 FWD V6-3.5L (2GR-FE) (2010)
Drive Belt: Service and Repair
Installation
Up to 08/2009
2GR-FE ENGINE MECHANICAL: DRIVE BELT: INSTALLATION
1. INSTALL V-RIBBED BELT
(a) Install the V-ribbed belt.
Text in Illustration
(b) Turn the V-ribbed belt tensioner counterclockwise and remove a 5 mm bi-hexagon wrench.
(c) After installing the V-ribbed belt, check that it fits properly in the ribbed grooves. Confirm that the belt has not slipped out of the grooves on
the bottom of the crank pulley by hand.
2. INSTALL FRONT FENDER APRON SEAL RH See: Service and Repair/Removal and Replacement/Engine Assembly/Installation
3. INSTALL FRONT FENDER LINER RH
4. INSTALL FRONT WHEEL RH
Torque : 103 Nm (1050 kgf-cm, 76 ft-lbf)
From 08/2009
2GR-FE ENGINE MECHANICAL: DRIVE BELT: INSTALLATION
1. INSTALL V-RIBBED BELT
(a) Install the V-ribbed belt.