RX 350 FWD V6-3.5L (2GR-FE) (2010)
Crankshaft Main Bearing Seal: Service and Repair
Installation
Up to 08/2009
2GR-FE ENGINE MECHANICAL: REAR CRANKSHAFT OIL SEAL: INSTALLATION
1. INSTALL ENGINE REAR OIL SEAL
(a) Apply MP grease to a new engine rear oil seal lip.
(b) Using SST and a hammer, tap in the engine rear oil seal.
SST : 09223-15030
SST : 09950-70010
09951-07150
Oil seal tap in depth:
-0.5 to 0.5 mm (-0.0196 to 0.0196 in.)
2. INSTALL DRIVE PLATE AND RING GEAR SUB-ASSEMBLY
(a) Using SST, hold the crankshaft pulley.
SST : 09213-70011
09213-70020
SST : 09330-00021
(b) Clean the 8 bolts and 8 bolt holes.
(c) Install the front drive plate spacer.