RX 350 FWD V6-3.5L (2GR-FE) (2010)
HINT
Align the pin of the front drive plate spacer with the pin hole of the crankshaft.
(d) Install the drive plate and ring gear sub-assembly and rear drive plate spacer onto the crankshaft.
(e) Apply adhesive to 2 or 3 threads of the 8 bolts.
Text in Illustration
Adhesive:
Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent
(f) In several steps, uniformly install and tighten the 8 bolts in the sequence shown in the illustration.
Torque : 83 Nm (846 kgf-cm, 61 ft-lbf)
3. INSTALL AUTOMATIC TRANSAXLE ASSEMBLY (for 2WD)
HINT
See the steps from "Install Automatic Transaxle Assembly" through "Install Engine Assembly with Transaxle" See: Transmission
and Drivetrain/Automatic Transmission/Transaxle/Service and Repair/Removal and Replacement/U660E Automatic
Transaxle/Transaxle Assembly/Installation.
4. INSTALL AUTOMATIC TRANSAXLE ASSEMBLY (for AWD)
HINT
See the steps from "Install Automatic Transaxle Assembly" through "Install Engine Assembly with Transaxle" See: Transmission
and Drivetrain/Automatic Transmission/Transaxle/Service and Repair/Removal and Replacement/U660F Automatic
Transaxle/Transaxle Assembly/Installation.
From 08/2009