RX 350 FWD V6-3.5L (2GR-FE) (2010)
13. REMOVE EXHAUST MANIFOLD TO HEAD GASKET LH
(a) Remove the exhaust manifold to head gasket LH from the cylinder head sub-assembly.
14. REMOVE AIR FUEL RATIO SENSOR (for Bank 2 Sensor 1) See: Powertrain Management/Computers and Control Systems/Oxygen
Sensor/Service and Repair/Air Fuel Ratio Sensor/Removal
From 08/2009
2GR-FE INTAKE / EXHAUST: EXHAUST MANIFOLD: REMOVAL
1. REMOVE NO. 2 RADIATOR ASSEMBLY
(a) Remove the No. 2 radiator assembly See: Cooling System/Radiator/Service and Repair/Removal.
2. REMOVE FRONT FLOOR COVER LH
(a) Disconnect the 3 clips.
(b) Remove the 2 screws, 4 bolts and front floor cover LH.
3. REMOVE FRONT NO. 3 EXHAUST PIPE SUB-ASSEMBLY
(a) Disconnect the 3 clamps and oxygen sensor connector (for Bank 1 Sensor 2).
(b) Remove the 4 bolts, 2 nuts, 2 compression springs and No. 3 exhaust pipe sub-assembly.
(c) Remove the 3 gaskets from the No. 3 exhaust pipe sub-assembly.
4. REMOVE MANIFOLD STAY
(a) Remove the bolt, nut and manifold stay.