RX 350 FWD V6-3.5L (2GR-FE) (2010)
(b) Remove the tail exhaust pipe assembly from the 4 exhaust pipe supports.
(c) Remove the gasket from the center exhaust pipe assembly.
5. REMOVE CENTER EXHAUST PIPE ASSEMBLY
(a) Remove the 2 bolts and 2 compression springs.
(b) Remove the center exhaust pipe assembly from the 2 exhaust pipe supports.
(c) Remove the gasket from the front No. 3 exhaust pipe sub-assembly.
6. REMOVE OXYGEN SENSOR (for Bank 1 Sensor 2) See: Powertrain Management/Computers and Control Systems/Oxygen Sensor/Service and
Repair/Heated Oxygen Sensor/Removal
7. REMOVE FRONT NO. 3 EXHAUST PIPE SUB-ASSEMBLY
(a) Remove the 2 bolts, 2 nuts and front No. 3 exhaust pipe sub-assembly.
(b) Remove the 2 gaskets from the front No. 3 exhaust pipe sub-assembly.
8. REMOVE FRONT EXHAUST PIPE ASSEMBLY
(a) Disconnect the No. 2 oxygen sensor connector (for Bank 2 Sensor 2).
(b) Loosen the bolt (A).
(c) Remove the 2 bolts (B), 2 nuts and front exhaust pipe assembly.
(d) Remove the gasket from the front exhaust pipe assembly.
9. REMOVE NO. 2 OXYGEN SENSOR (for Bank 2 Sensor 2) See: Powertrain Management/Computers and Control Systems/Oxygen
Sensor/Service and Repair/Heated Oxygen Sensor/Removal