RX 350 FWD V6-3.5L (2GR-FE) (2010)
(b) Remove the O-ring from the air conditioning tube and accessory assembly.
NOTICE:
Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.
20. REMOVE UPPER RADIATOR SUPPORT See: Engine, Cooling and Exhaust/Cooling System/Radiator/Service and Repair/Removal
21. REMOVE COOLER CONDENSER ASSEMBLY
(a) Remove the 2 bolts and 2 cooler brackets.
(b) Disengage the 2 guides and Remove the cooler condenser assembly as shown in the illustration.
Text in Illustration
NOTICE:
*
Due to the potential of damaging the brackets, do not allow the brackets to touch the vehicle body etc. while installing the
condenser.
*
Do not allow the condenser to contact the vehicle body or radiator while installing the condenser.
*
When storing the condenser, do not put the brackets facing down (toward the ground) because this may cause damage to the
brackets.
From 08/2009
HEATING / AIR CONDITIONING: CONDENSER: REMOVAL
1. PRECAUTION (w/ Navigation System for HDD)
NOTICE:
After the engine switch is turned off, the display and navigation module display (HDD navigation system) records various types of
memory and settings. As a result, after turning the engine switch off, make sure to wait at least 60 seconds before disconnecting the
cable from the negative (-) battery terminal.
2. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM See: Service and Repair
3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL