RX 350 FWD V6-3.5L (2GR-FE) (2010)
Refrigerant Pressure Sensor / Switch: Service and Repair
Installation
Up to 08/2009
HEATING / AIR CONDITIONING: AIR CONDITIONING PRESSURE SENSOR: INSTALLATION
1. INSTALL AIR CONDITIONING PRESSURE SENSOR
(a) Sufficiently apply compressor oil to a new air conditioning pressure sensor.
Compressor oil:
ND-OIL 8 or equivalent
(b) Install the new air conditioning pressure sensor.
Torque : 11 Nm (110 kgf-cm, 8 ft-lbf)
NOTICE:
*
Do not deform the piping.
*
Make sure to confirm that the piping does not disengage from the plastic clamp.
(c) Connect the connector.
2. INSTALL ENGINE ROOM SIDE COVER See: Body and Frame/Bumper/Front Bumper/Service and Repair/Removal and
Replacement/Installation
3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning/Repair Instruction - Initialization.
4. CHARGE WITH REFRIGERANT See: Service and Repair
5. WARM UP ENGINE See: Service and Repair
6. INSPECT FOR REFRIGERANT LEAK See: Service and Repair
From 08/2009
HEATING / AIR CONDITIONING: AIR CONDITIONING PRESSURE SENSOR: INSTALLATION
1. INSTALL AIR CONDITIONING PRESSURE SENSOR
(a) Sufficiently apply compressor oil to a new air conditioning pressure sensor.
Compressor oil:
ND-OIL 8 or equivalent