RX 350 FWD V6-3.5L (2GR-FE) (2010)
the vehicle.
(h) Do not apply grease, detergent, oil or water to the SRS parts. If applied, immediately wipe it off with a dry cloth.
(i) When deploying or storing the SRS parts, avoid places with a high temperature (ambient temperature of 93°C (199°F) or higher for an airbag
and 80°C (176°F) or higher for a pretensioner) and high humidity, and keep them away from electrical noise.
(j) Do not stack or place anything on top of the SRS parts.
(k) When disposing of the vehicle or an SRS part by itself, deploy it using SST before disposal. Deploy the SRS parts in a safe place away from
electrical noise.
HINT
*
Disposal of the steering pad See: Restraint Systems/Air Bag Systems/Air Bag/Service and Repair/Procedures/Steering Pad
*
Disposal of the driver side knee airbag assembly See: Restraint Systems/Air Bag Systems/Air Bag/Service and
Repair/Procedures/Knee Airbag Assembly (for Driver Side)
*
Disposal of the front passenger side knee airbag assembly See: Restraint Systems/Air Bag Systems/Air Bag/Service and
Repair/Procedures/Knee Airbag Assembly (for Front Passenger Side)
*
Disposal of the front passenger airbag assembly See: Restraint Systems/Air Bag Systems/Air Bag/Service and
Repair/Procedures/Front Passenger Airbag Assembly
*
Disposal of the curtain shield airbag assemblies See: Restraint Systems/Air Bag Systems/Air Bag/Service and
Repair/Procedures/Curtain Shield Airbag Assembly
*
Disposal of the front seat side airbag assemblies See: Restraint Systems/Air Bag Systems/Air Bag/Service and
Repair/Procedures/Front Seat Side Airbag Assembly
*
Disposal of the rear seat side airbag assemblies See: Restraint Systems/Air Bag Systems/Air Bag/Service and Repair/Procedures/Rear
Seat Side Airbag Assembly
*
Disposal of the front seat outer belt assemblies See: Restraint Systems/Seat Belt Systems/Seat Belt/Service and
Repair/Procedures/Front Seat Outer Belt Assembly
*
Disposal of the rear seat outer belt assemblies See: Restraint Systems/Seat Belt Systems/Seat Belt/Service and Repair/Procedures/Rear
Seat Outer Belt Assembly
(l) Never inspect the resistance of the SRS parts.
CAUTION:
Never measure the resistance of the SRS parts because current from the tester may cause the SRS parts to deploy.
4. PRECAUTION FOR DISPOSAL OF SRS PARTS (NOT DEPLOYED)
(a) Before performing pre-disposal deployment of any SRS parts, review and closely follow all applicable environmental and hazardous material
regulations. Pre-disposal deployment may be considered hazardous material treatment.