RX 350 FWD V6-3.5L (2GR-FE) (2010)
Tire Pressure Module: Service and Repair
Removal
Up to 08/2009
TIRE PRESSURE MONITORING: TIRE PRESSURE WARNING ECU: REMOVAL
1. PRECAUTION (w/ Navigation System for HDD)
NOTICE:
After the engine switch is turned off, the display and navigation module display (HDD navigation system) records various types of
memory and settings. As a result, after turning the engine switch off, make sure to wait at least 60 seconds before disconnecting the
cable from the negative (-) battery terminal.
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning/Repair Instruction - Initialization.
3. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY See: Dashboard / Instrument Panel/Service and Repair/Removal
and Replacement/Removal
4. REMOVE TIRE PRESSURE WARNING ECU
(a) Disengage the 2 claws to remove the tire pressure warning ECU.
HINT
Slide the tire pressure warning ECU towards the rear of the vehicle to remove it.
(b) Disconnect the connector.
From 08/2009
TIRE PRESSURE MONITORING: TIRE PRESSURE WARNING ECU: REMOVAL
1. PRECAUTION (w/ Navigation System for HDD)
NOTICE:
After the engine switch is turned off, the display and navigation module display (HDD navigation system) records various types of
memory and settings. As a result, after turning the engine switch off, make sure to wait at least 60 seconds before disconnecting the
cable from the negative (-) battery terminal.
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning/Repair Instruction - Initialization.