RX 350 FWD V6-3.5L (2GR-FE) (2010)
NOTICE:
Be sure to read Precaution thoroughly before servicing See: Steering and Suspension/Suspension/Service Precautions/Suspension
Control System.
(b) w/ Navigation System for HDD:
NOTICE:
After the engine switch is turned off, the display and navigation module display (HDD navigation system) records various types of
memory and settings. As a result, after turning the engine switch off, make sure to wait at least 60 seconds before disconnecting the
cable from the negative (-) battery terminal.
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning/Repair Instruction - Initialization.
3. REMOVE REAR WHEEL
4. REMOVE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY
(a) Disconnect the connector.
(b) Remove the bolt and disengage the guide.
(c) Remove the bolt and disengage the guide.
(d) Remove the 2 nuts and rear height control sensor sub-assembly.
NOTICE:
Do not drop the rear height control sensor sub-assembly. If it is dropped, replace it with a new one.