RX 350 FWD V6-3.5L (2GR-FE) (2010)
Alignment: Service and Repair
Rear Wheel Alignment
Up to 08/2009
ALIGNMENT / HANDLING DIAGNOSIS: REAR WHEEL ALIGNMENT: ADJUSTMENT
NOTICE:
If the wheel alignment has been adjusted, and if suspension or underbody components have been removed/installed or replaced, be
sure to perform the following initialization procedure in order for the system to function normally:
*
Perform zero point calibration of the yaw rate and acceleration sensor and test mode inspection.
1. PRECAUTION (w/ Air Suspension)
NOTICE:
Be sure to read Precaution thoroughly before servicing See: Steering and Suspension/Suspension/Service Precautions/Suspension
Control System.
2. INSPECT TIRES
(a) Inspect the tires See: Wheels and Tires/Testing and Inspection/Component Tests and General Diagnostics.
3. MEASURE VEHICLE HEIGHT See: Front Wheel Alignment
4. INSPECT CAMBER
Camber (Unloaded Vehicle):
HINT
Camber is not adjustable. If the measurement is not within the specified range, inspect the suspension parts for damage and/or wear,
and replace them if necessary.
5. INSPECT TOE-IN
Text in Illustration
Toe-in (Unloaded Vehicle):
If the toe-in is not within the specified range, adjust it at the rear No. 2 suspension arms.