RX 350 FWD V6-3.5L (2GR-FE) (2010)
4. BEFORE FILLING TRANSAXLE WITH FLUID
(a) Lift the vehicle.
NOTICE:
Set the vehicle on a lift so that the vehicle is kept level when it is lifted up.
(b) Remove the 2 bolts, clip and front fender apron seal LH.
5. PERFORM INITIAL FILLING
NOTICE:
If the transaxle is hot (ATF temperature is high), wait until the fluid temperature becomes the same as the ambient temperature
before starting the following procedure. (Recommended ATF temperature: around 20°C [68°F])
(a) Remove the refill plug and gasket from the automatic transaxle.
NOTICE:
After performing any of the following operations, it is not necessary to perform the initial filling procedure. Proceed to the Add
Specified Amount of Fluid procedure.
(b) Using a 6 mm hexagon socket wrench, remove the overflow plug and gasket from the automatic transaxle.