RX 350 FWD V6-3.5L (2GR-FE) (2010)
/Page-1236016.png)
(b) Disconnect the CAN No. 2 junction connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Text in Illustration
NG -- REPAIR OR REPLACE CAN BUS BRANCH WIRE OR CONNECTOR (CAN NO. 1 J/C - CAN NO. 2 JUNCTION
CONNECTOR)
OK -- Continue to next step.
19. CHECK FOR SHORT IN CAN BUS WIRE (CAN NO. 2 J/C - CERTIFICATION ECU)
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Text in Illustration
NG -- CHECK FOR SHORT IN CAN BUS WIRES (CERTIFICATION ECU)
OK -- Continue to next step.
20. CHECK FOR SHORT IN CAN BUS WIRE (CAN NO. 2 J/C - SKID CONTROL ECU)
(a) Disconnect the skid control ECU connector.
