RX 350 FWD V6-3.5L (2GR-FE) (2010)
/Page-1236028.png)
11. CHECK FOR SHORT IN CAN BUS WIRES (CAN NO. 1 J/C)
(a) Reconnect the CAN No. 1 junction connector.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Text in Illustration
NOTICE:
The resistance must be measured after the main wire connected ECUs (ECM and certification ECU), and the CAN No. 1 and No. 2
junction connectors are reconnected.
NG -- REPLACE CAN NO. 1 JUNCTION CONNECTOR
OK -- Continue to next step.
12. CHECK FOR SHORT IN CAN BUS WIRES (COMBINATION METER)
(a) Reconnect the combination meter connector.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Text in Illustration
NG -- REPLACE COMBINATION METER ASSEMBLY See: Instrument Panel, Gauges and Warning Indicators/Instrument Cluster
/ Carrier/Service and Repair/Removal and Replacement/Combination Meter/Removal
OK -- Continue to next step.
