RX 350 FWD V6-3.5L (2GR-FE) (2010)
(a) Using the Techstream, select "CAN Bus Check" from "System Select".
4. DTC TABLE BY ECU
HINT
*
In the CAN communication system, CAN communication system DTCs can be displayed by the ECU using the Techstream.
*
If CAN communication system DTCs are output, trouble cannot be determined only by the DTCs. Perform troubleshooting
according to How to Proceed with Troubleshooting See: Initial Inspection and Diagnostic Overview/CAN Communication
System/How to Proceed With Troubleshooting.
(a) ECM / Techstream Display "Engine"
HINT
*
DTC communication uses the CAN communication system.
*
*1: The ECM is malfunctioning if only U0101 is output. Refer to SFI System See: Testing and Inspection/Diagnostic Trouble
Code Tests and Associated Procedures/U Code Charts/U0101.
*
*2: Dynamic radar cruise control system DTC
*
*3: If U0235 or U1102 is output alone, the CAN communication is normal See: Testing and Inspection/Diagnostic Trouble Code
Tests and Associated Procedures/U Code Charts/U0235for U0235, See: Testing and Inspection/Diagnostic Trouble Code Tests
and Associated Procedures/U Code Charts/U1102 for U1102).
(b) TCM / Techstream Display "ECT"
HINT
*
DTC communication uses the CAN communication system.
*
*4: The ECM is malfunctioning if only U0100 is output. Refer to Automatic Transaxle System (U660E: See: Testing and
Inspection/Diagnostic Trouble Code Tests and Associated Procedures/U Code Charts/U0100, U660F: See: Testing and
Inspection/Diagnostic Trouble Code Tests and Associated Procedures/U Code Charts/U0100).
(c) Main Body ECU (Multiplex Network Body ECU) / Techstream Display "Main Body"