RX 350 FWD V6-3.5L (2GR-FE) (2010)
OK -- Continue to next step.
2. CHECK HARNESS AND CONNECTOR (POWER SOURCE TERMINAL)
(a) Turn the engine switch on (IG).
(b) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Text in Illustration
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR (POWER SOURCE CIRCUIT)
OK -- Continue to next step.
3. CHECK HARNESS AND CONNECTOR (GROUND TERMINAL)
(a) Turn the engine switch off.
(b) Disconnect the power steering ECU connector.
Text in Illustration
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR (GROUND CIRCUIT)
OK -- REPLACE POWER STEERING ECU See: Relays and Modules/Relays and Modules - Steering and Suspension/Relays and
Modules - Steering/Steering Control Module/Service and Repair/Removal
Certification ECU Communication Stop Mode
NETWORKING: CAN COMMUNICATION SYSTEM: Certification ECU Communication Stop Mode
- Certification ECU Communication Stop Mode