RX 350 FWD V6-3.5L (2GR-FE) (2010)
3. CHECK HARNESS AND CONNECTOR (GROUND TERMINAL)
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Text in Illustration
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR (GROUND CIRCUIT)
OK -- REPLACE MULTIPLEX NETWORK BODY ECU (MAIN BODY ECU) See: Body Control Module/Service and
Repair/Removal
Up to 08/2009
NETWORKING: CAN COMMUNICATION SYSTEM: Navigation ECU Communication Stop Mode
- Navigation ECU Communication Stop Mode
DESCRIPTION
WIRING DIAGRAM
INSPECTION PROCEDURE
NOTICE:
*
Turn the engine switch off before measuring the resistances between CAN bus main wires and between CAN bus branch wires.
*
Turn the engine switch off before inspecting CAN bus wires for a ground short.