RX 350 FWD V6-3.5L (2GR-FE) (2010)
Text in Illustration
NG -- REPAIR OR REPLACE CAN BUS BRANCH WIRE OR CONNECTOR (CAN NO. 2 J/C - NAVIGATION ECU)
OK -- REPLACE DISPLAY AND NAVIGATION MODULE DISPLAY (NAVIGATION ECU) See: Accessories and Optional
Equipment/Navigation System/Service and Repair/Navigation Receiver (for HDD)/Removal
Scan Tool Testing and Procedures
NETWORKING: LIN COMMUNICATION SYSTEM: DATA LIST / ACTIVE TEST
1. DATA LIST
HINT
Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read
without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be
discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save
diagnostic time.
NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values
when deciding whether a part is faulty or not.
(a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Main Body / Data List.
(e) Read the Data List according to the display on the Techstream.
Main Body