RX 350 FWD V6-3.5L (2GR-FE) (2010)
*
Be sure to perform this step with all accessories off.
*
Make sure that the shift lever is in N.
(e) Enter the following menus: Powertrain/ Engine / Data List/ Throttle Sensor Position. Fully depress the accelerator pedal and check that the
value is 60% or more.
(f) Perform a road test and confirm that there are no abnormalities.
From 08/2009
2GR-FE ENGINE CONTROL: THROTTLE BODY: INSTALLATION
1. INSTALL THROTTLE BODY
(a) Install a new gasket to the intake air surge tank assembly.
Text in Illustration
(b) Install the throttle body and wire harness clamp stay to the intake air surge tank assembly with the 4 bolts.
Torque : 10 Nm (102 kgf-cm, 7 ft-lbf)
(c) Connect the throttle body connector and wire harness clamp.
(d) Connect the 2 water by-pass hoses to the throttle body.
2. INSTALL AIR CLEANER ASSEMBLY
(a) Insert the tab of the air cleaner assembly to the hole of the vehicle body as shown in the illustration.
Text in Illustration