RX 350 FWD V6-3.5L (2GR-FE) (2010)
Knock Sensor: Service and Repair
Installation
Up to 08/2009
2GR-FE ENGINE CONTROL: KNOCK SENSOR: INSTALLATION
1. INSTALL KNOCK CONTROL SENSOR
(a) Install the 2 knock control sensors with the 2 bolts as shown in the illustration.
Torque : 20 Nm (204 kgf-cm, 15 ft-lbf)
NOTICE:
Make sure that each knock control sensor is in the correct position.
(b) Connect the 2 knock control sensor connectors.
2. INSTALL INTAKE MANIFOLD
(a) Install the intake manifold See: Engine, Cooling and Exhaust/Engine/Intake Manifold/Service and Repair/Installation.
From 08/2009
2GR-FE ENGINE CONTROL: KNOCK SENSOR: INSTALLATION
1. INSTALL KNOCK CONTROL SENSOR
(a) Install the 2 knock control sensors with the 2 bolts as shown in the illustration.
Torque : 20 Nm (204 kgf-cm, 15 ft-lbf)
NOTICE:
Make sure that each knock control sensor is in the correct position.
(b) Connect the 2 knock control sensor connectors.
2. INSTALL INTAKE MANIFOLD
(a) Install the intake manifold See: Engine, Cooling and Exhaust/Engine/Intake Manifold/Service and Repair/Installation.