RX 350 FWD V6-3.5L (2GR-FE) (2010)
(c) Connect the 3 clamps and oxygen sensor connector (for Bank 1 Sensor 2).
5. INSPECT FOR EXHAUST GAS LEAK
6. INSTALL FRONT FLOOR COVER LH See: Engine, Cooling and Exhaust/Exhaust System/Exhaust Manifold/Service and Repair/Installation
From 08/2009
2GR-FE ENGINE CONTROL: HEATED OXYGEN SENSOR: INSTALLATION
1. INSTALL NO. 2 OXYGEN SENSOR (for Bank 2 Sensor 2)
(a) Using SST, install the No. 2 oxygen sensor to the front exhaust pipe assembly.
Text in Illustration
SST : 09224-00010
without SST - Torque : 44 Nm (449 kgf-cm, 33 ft-lbf)
with SST - Torque : 40 Nm (408 kgf-cm, 30 ft-lbf)
NOTICE:
*
The "with SST" torque value is effective when using SST with a fulcrum length of 30 mm (1.18 in.).
*
The "with SST" torque value is effective when using a torque wrench with a fulcrum length of 300 mm (11.81 in.) See: Service
Precautions.
*
The "with SST" torque value is effective when SST is parallel to the torque wrench.
2. INSTALL FRONT EXHAUST PIPE ASSEMBLY See: Engine, Cooling and Exhaust/Exhaust System/Exhaust Pipe/Service and
Repair/Installation
3. INSTALL NO. 3 FRONT EXHAUST PIPE SUB-ASSEMBLY
(a) Using a vernier caliper, measure the free length of the compression springs.